LIMENTE LED-LINEA is a versatile work- and mood light that can be used under the kitchen cabinets, but also as an indirect light on top of cabinets, behind mirrors, in plinths, in ceilings etc. The light is stylishly continuous with no interrupting connection points, so that a uniform profile provides even light throughout the area. The power supply cable at both ends of the lamp enables the use of LED-LINEA as two separate luminaires. LED-LINEA can also be used in its full length (2 m or 4 m), whereby the power cord of the other end is cut off. LED-tape can be shortened at 3,3 cm intervals to the desired length, allowing different individual solutions. A range of accessories, such as corner pieces, gives the installation stylish look.
LED-LINEA has 2- or 4-meter-long rails with all the needed accessories (corner-, end- and extension parts and clips), light strip and 100 cm profile for the power supply cable. NOTE! The power supply must be ordered separately. The light strip can be used in its full length, whereby the power cord of the other end is cut off. The power supply cord at both ends of the luminaire allows the light to be used as two separate lights.
LIMENTE LED-LINEA profile light is available in three different versions. The standard model (Ra> 80, 4000 K), LUX (Ra> 95, 3000 K and 4000 K) and an adjustable CCT-model (Ra> 80, 2700K - 6000K).
By adjusting the lights, it is easy to create appropriate lighting for different occasions. By dimming LIMENTE LED-LINEA you can change your home’s lighting from efficient and bright to dim and cosy. You can use the same switch to adjust all the LIMENTE lights in the room, including various ceiling-, panel- and profile lights. The lamps adjust smoothly at the same time, while simultaneously changing the ambience of the space.
LIMENTE LED-LINEA is dimmable with wireless LIMENTE SMART 350 (No. 640350) and LIMENTE SMART 400-series 24 V dimmer (No. 640420) and wireless wall switches (No. 640411, 640421 ja 640422, 640424). In both options, the dimmer is installed between the power supply and the luminaires and it includes a corresponding manifold as it is in the power supply. 6 pairs of LIMENTE luminaires can be connected to the dimmer, as long as the maximum load (W) of the power supply is not exceeded.
The LIMENTE LED-LINEA is fast and easy to mount with the supplied hardware.
The power supply cable (for example hidden behind the cabinet) is put in place so that the male connector comes close to the power supply and the female connector near the LED-LINEA profile. The light profile is cut to the desired length and fastened to its place with the supplied clips. The light strip is pressed onto the luminaire profile using 2-sided tape and finally the power supply cable is pressed against the light strip and the power supply. All electrical connections are made simply by quick connectors.
The power supply cable at both ends of the lamp enables the use of LED-CORNER as two separate luminaires. LED-LINEA can also be used in its full length (2 m or 4 m), whereby the power cord of the other end is cut off. LED-LINEA can be shortened at 3,3 cm intervals to the desired length. At both ends there is a standard 5 cm + 300 cm long cord. If this is not enough, you can order an (3 m) extension cord (No. 681588). Extension cables can be fitted with a maximum of 1 pcs of luminaires, with a maximum cable length of up to 6 m. Be aware of the adequate length of the cord and that the maximum load (W) on the power supply is not exceeded.
- aluminum profile 2 m
- end pieces
- corner pieces
- led-ribbon 2 m, driver in both ends