Continuous profile light
LIMENTE LED-SLIM is a versatile lighting system that allows you to custom build your own lighting system. The luminaire is available in colour temperature of 3000 K and 4000 K versions and allows you to build unified lighting with corners also illuminated. The LED-SLIM suits well for kitchen space, display cabinet, wardrobe, store shelves and everywhere, where stylish, uniform and efficient lighting is desired. The LIMENTE LED-SLIM system is available in sections of 10, 20, 30, 50 and 100 cm lengths, plus 90-degree angle piece and a flexible corner piece.
Dimming and lighting control
By adjusting the lights, it is easy to create appropriate lighting for different occasions. By dimming LIMENTE LED-SLIM you can change your home’s lighting from efficient and bright to dim and cosy. You can use the same switch to adjust all the LIMENTE lights in the room, including various ceiling-, panel- and profile lights. The lamps adjust smoothly at the same time, while simultaneously changing the ambience of the space.
LIMENTE LED-SLIM is dimmable with wireless LIMENTE SMART 350 (No. 640350) and LIMENTE SMART 400-series 24 V dimmer (No. 640420) and wireless wall switches (No. 640411, 640421 and 640422, 640424). In both options, the dimmer is installed between the power supply and the luminaires and it includes a corresponding manifold as it is in the power supply. 6 pairs of LIMENTE luminaires can be connected to the dimmer, as long as the maximum load (W) of the power supply is not exceeded.
The system is simple to design and implement by following the instructions below.
1. First look where the stream comes from and select either end power supply (629203) or intermediate power supply (629313). The first will bring the current to the end of the light profile and, in the latter, a 20 cm long intermediate current can be placed anywhere, so that the light continues in both directions.
2. Choose whether to place the light on the front edge of the cabinet or close the back wall. When placed in the front edge, it is advisable to install the light directly downwards and correspondingly at the rear edge, depending on the height of the space, either at an angle of 15 or 45 degrees. In this way, light will always be optimally applied to the table level. When installing the rear edge, a flexible 1 to 180-degree angle span must be used as an angular pivot.
3. Select the lamps to be placed in succession so that their total length is approximately 10 cm. Under the drying cabinet, select a sufficiently wide luminaire so that you can attach it to the bottom of the adjacent cabinets.
Be sure to observe the total angles as well. Do not attempt to dimension the length exactly according to the width of the top cabinets. The end result is stylish and the light output is good enough even if there is empty space at the ends.
4. Possible angles can be made either in fixed 90 ° corner areas or in a flexible 0-180-degree angle field. Always use a flexible corner piece at all other angles except 90 degrees.
Ei liittyviä artikkeleita